Gauging of hexagon sockets (ISO ); German version EN ISO ISO Gauging of hexagon sockets. standard by International Organization for Standardization, 01/15/ View all product details. Buy NF EN ISO Gauging Of Hexagon Sockets from SAI Global.
|Genre:||Health and Food|
|Published (Last):||27 November 2007|
|PDF File Size:||1.48 Mb|
|ePub File Size:||17.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
Technical Committee Mechanical fasteners Publisher and printing: All rights reserved; No part of this publication may be reproduced or utilized in any form or by any means — elec- tronic, mechanical, photocopying or any other data carriers without prior permission from ON! Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the Central Secretariat or to any CEN member. A version in any other language made by translation under the isso of a CEN member into its own language and notified to the Central Secretariat has the same status as the official versions.
This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by Julyand conflicting national standards shall be withdrawn at the latest by July Endorsement notice The text of ISO In accordance with Adobe’s licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to lso installed on the computer performing the editing.
In downloading this file, parties accept therein the responsibility of not infringing Adobe’s licensing policy. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing.
NBN EN ISO 23429
Every care has been taken to ensure that the file is suitable ido use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s member body in the country of the requester.
The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented 233429 that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. The main task of technical committees is to prepare International Standards.
Draft International Standards adopted by the technical committees are circulated uso the member bodies for voting.
NBN EN ISO | NBN
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be ixo responsible for identifying any or all such patent rights.
This third edition cancels and replaces the second edition ISO NOTE Particular attention is drawn to the note in Table 2 and to Table 3 concerning the limitation on ultimate tensile load. If, in special cases, specifications other than those listed in this International Standard are required, they should be selected 32429 existing International Standards, e. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document including any amendments applies.
Symbols and designations of dimensions are defined in ISO Alternative form of socket permissible For broached sockets which are at the maximum limit of size the overcut resulting from drilling shall not exceed of the length of any flat of the socket which is. Intermediate nominal lengths according to ISO are permissible.
Hexagon socket button head screw ISO – M12 40 – Requirements for non-electrolytically applied zinc flake coatings are covered in ISO Acceptability Acceptance procedure is covered in ISO They shall nevertheless meet the other material and property requirements for the respective property class specified in ISO ieo In addition, when full-size screws are loaded using the type of testing fixture illustrated in ISOthey shall withstand, without fracture, the minimum ultimate tensile loads given in Table 3.
Table 3 — Minimum ultimate tensile loads for hexagon socket button head screws of the values specified in ISO Thread Property class 8.