Circuit that is used in DENON’s high-end integrated amplifiers and has been criti- The PMAAE employs DENON’s Signal Level Divided Construction. A broad-branded circuit technique and a single-stage output circuit on high- current transistors are used in PMAAE. The equalizer, loudness scheme ( both. Denon PMAAESilver Amplifier. Great Integrated Amplifier.

Author: Vuzshura Samushicage
Country: Liechtenstein
Language: English (Spanish)
Genre: Relationship
Published (Last): 20 November 2007
Pages: 61
PDF File Size: 1.10 Mb
ePub File Size: 8.71 Mb
ISBN: 599-2-59936-418-6
Downloads: 46702
Price: Free* [*Free Regsitration Required]
Uploader: Faelar

Since I was interested to re-check the balance and frequency response tests on a fresh sample, I borrowed a brand-new PMAAE and had Newport Test Labs rerun the balance and frequency response tests on this second sample.

And for the price, excellent hi-fi performance. Of some significance was the CCIF intermodulation test, which showed two sidebands at 18kHz and 21kHz surrounding the 19kHz and 20kHz test signals but only the tiniest re-generated signal at 1kHz, at —dB.

Denon PMAAE Amplifier With Phono Input | eBay

The Denon was no slouch into 4O loads either, producing watts Stability into an extremely capacitative load dehon excellent. As you can see, what little ringing there was was quickly damped.


Even the two pna-700ae were an excellent —95dB. The overall THD figures are tabulated in the chart, at 0. The 1kHz wave was nearly perfect, and the 10kHz wave showed a very fast rise-time with very little rounding.

You can download a pdf of the original magazine pages on which this review was published, which includes ;ma-700ae the graphs, test result charts, tabulated results and oscillograms mentioned in the test results, by clicking HERE or on the graphic at right.

Channel separation was good, with a best of 79dB at 20Hz, reducing to 72dB at 1kHz and 48dB at 20kHz, however the balance between the left and right channels was very slightly out, with a 1.

Denon PMAAE Amplifier Review & Test | Hi-Fi | Review | AVHub

At 1kHz, the Denon delivered a little more again watts, or David Ella and tested by Steve Holding Magazine: However, all the low-order harmonics were pms-700ae or below —80dB 0.

Distortion increased at rated output, as would be expected, with the lower-order harmonics increasing in level, and additional, higher-order components appearing above the noise floor. This is not a large error: You can clearly deenon the power supply limitation at 20Hz however, where the Denon returned watts Square wave performance was excellent, with the Hz square wave showing negligible tilt and almost no curvature across the flats.


denoh This time around the results were near-perfect, with channel balance improving to 0. With the tone controls engaged, the low-frequency response slopes down from 1kHz to end up 2dB down at 80Hz and a further 0.

Phase error at 20kHz was a little on the high side, but nothing to be concerned about. With a 4O load, the second harmonic component crept up to —90dB pmw-700ae. Damping factor was very good: Distortion was very low, as you can tell from the spectrograms.

This is exceptional performance, by any standard.